墻面出現裂縫或開裂等問題時,大家首先能猜到涂料質量有問題嗎?有一句話在膩?zhàn)臃坌袠I(yè)是“三分鐘涂料,七分鐘施工”,可見出現的墻面問題大多是因?yàn)槭┕ひ鸬?。今天美麗的巨郎牌膩?zhàn)雍y跟大家一起了解,墻面開裂的原因是什么,以及當墻面出現問題時我們應該如何解決?
When cracks or cracks occur on the wall, can you first guess that there is a problem with the quality of the paint? There is a saying in putty powder industry that "three minutes paint, seven minutes construction". It can be seen that most of the wall problems are caused by construction. Today, the beautiful Julang putty paste makeup with you to understand, what is the cause of wall cracking, and when there are problems in the wall, how should we solve them?
1. 建筑上的缺陷會導致墻體開裂,房屋本身的一些質量問題,如保溫層出現裂縫,墻體開槽后不正確的修補和油漆會導致墻面收縮和裝修后出現裂縫。如果是這樣,只需沿著裂縫的方向,均勻地勾去墻面上的勾痕,用彈性膩?zhàn)拥灼?,用粘膠貼緊縫帶,然后整平,做底漆、面漆。
1. Defects in buildings will lead to wall cracking, and some quality problems of the house itself, such as cracks in insulation layer, improper repairing and painting after wall grooving will lead to wall shrinkage and cracks after repair. If so, just along the direction of the cracks, evenly draw off the marks on the wall, use elastic putty primer, stick the seam band with viscose, and then leveling, do primer and topcoat.
2. 如果膩?zhàn)庸蔚锰穸_(kāi)裂,如果膩?zhàn)庸蔚锰褚淮?,干燥不均就?huì)發生,這就會導致開裂。這種開裂一般出現在墻角或墻面不寧的地方,要解決這種情況的墻面開裂,只需局部打磨,然后用膩?zhàn)釉谙旅孀鲂扪a(bǔ)就可以了。
2. If the putty is scraped too thick and cracked, if the putty is scraped too thick once, uneven drying will occur, which will lead to cracking. This kind of cracking usually occurs in the corner or in the uneasy place of the wall. To solve this kind of cracking, only local polishing is needed, and then putty is used to repair under it.
墻面呈現裂痕一定是濟南膩?zhàn)臃鄣馁|(zhì)量有問題嗎?
Is there a problem with the quality of Jinan putty powder when cracks appear on the wall?
3.水泥砂漿抹層墻面開裂的石膏,水泥砂漿配料沒有干灰,分裂引起的水泥砂漿干透后,引發了乳膠漆裂紋,裝修完成這種情況下如果你想補救的墻面開裂相對會有一些麻煩,如果整個墻面出現不規則裂縫,再次作為一個整體,需要建設。
3. Cement mortar plastering wall cracking gypsum, cement mortar ingredients without dry ash, split caused by cement mortar drying, resulting in latex paint cracks, decoration completed in this case if you want to remedy the wall cracking will be relatively troublesome, if the whole wall appears irregular cracks, once again as a whole, need to be constructed.
4. 墻面乳膠漆裂紋涂料刷底漆涂料,如油漆變干之前次開始刷過了一段時間后,收縮率不同,導致表面油漆開裂,如果只是表面漆膜裂紋,用細砂紙將裂紋,描繪了一幅新的刷就可以了?,F(xiàn)在你知道了,墻面開裂除了房子本身的質量問題外,由于施工操作不當?shù)脑?,與涂料本身沒有太大的關系。所以裝修業主在選擇涂料的同時,更應注重進行墻面粉刷時的工藝,這樣才能盡早避免出現墻面開裂的問題。
4. Wall latex crack paint brushing primer paint, such as paint before drying for the first time after brushing for a period of time, the shrinkage rate is different, resulting in surface paint cracking, if only surface paint film cracks, with fine sandpaper will crack, depict a new brush on it. Now you know, apart from the quality problems of the house itself, wall cracking has little to do with the paint itself due to improper construction operation. Therefore, while choosing paint, decoration owners should pay more attention to the process of wall painting, so as to avoid wall cracking as soon as possible.
補充:基層墻體的處理往往需要多個工序,但如何處理墻體的裂縫呢?首先在接縫處用泡沫劑進行處理,可以使建筑物的接縫不透水、不透水。第二是用油漆專用紙帶進行密封,后再用粘性黃帶封邊,這樣可以有效保證基層牢固穩定,避免日后墻面開裂。這樣,業主在裝修時可以與油漆師傅溝通,大限度地保證基層處理到位。晚,當然,也有一些因?yàn)槟佔邮湛s引起的開裂問題,當次建筑膩?zhàn)恿⒓床辉俑晒文佔?然后刷漆,輕易造成膩?zhàn)痈珊蟊砻骈_(kāi)裂,如果遇到這樣的陰雨天氣臺風,尤其必須注意長時間干燥后遍刷墻體,連續下雨,空氣太濕,墻面不容易干,如果壓碎,有時草率的施工可能會留下墻體開裂后的后遺癥,維修更麻煩,首先要刮的東西會先開裂,再用膩?zhàn)犹畛?,如涂完油漆后再干擦。此外,修?fù)后是否會再次開裂也是一個問題。經常在施工中的業主也可以嘗試用太陽能燈照亮墻面,以加快墻面干燥的速度。
Supplement: the treatment of base wall often requires multiple processes, but how to deal with cracks in the wall? First, the foam treatment is applied to the joints to make the joints of the building impervious and impervious. The second is to seal with special paper tape for paint, and finally seal with viscous yellow tape, which can effectively ensure the stability of the base and avoid wall cracking in the future. In this way, the owner can communicate with the painter when decorating to ensure that the grass-roots treatment is in place to the greatest extent. Late, of course, there are also some cracking problems caused by putty shrinkage. When the first building putty is no longer dry and scrapes putty, and then paints, it will easily cause putty surface cracking after drying. In case of such rainy weather typhoon, we must pay special attention to brushing the wall for the first time after long drying, continuous rain, the air is too wet, and the wall surface is not easy. Dry, if crushed, sometimes sloppy construction may leave behind the sequelae of wall cracking, maintenance is more troublesome, the first thing to scrape will crack, then fill with putty, such as paint after dry wiping. In addition, whether it will crack again after repair is also a question. Owners often in construction can also try to use solar lights to illuminate the wall to speed up drying.